Features

lDual-Port MIPI® DSI/CSI Receiver

• Compliant with D-PHY1.2 ,DSI1.2/CSI-2 1.00 and DCS 1.02.00
• 1~2 Configurable Port
• 1 Clock Lane and 1~4 Configurable Data Lanes
• 80Mb/s~2Gb/s per Data Lane
• Data Port ,Data Lane and Polarity Swapping
• Internal Rterm Calibration with Less than 5% Error
• Programmable Equalization
• Burst Mode and Non-Burst Mode Supported
• Dual Port Odd-Even Mode and Left-Right Mode Supported
• Support up to 24-bit RGB and YUV Data Format

lHDMI1.4 Transmitter

• Compliant with HDMI1.4 and HDCP1.4
• Resolution Up to 4K 30Hz
• Programmable output swing and pre-emphasis
• Fully hardware controlled or optional software controlled HDCP operations
• Integrated CEC controller
• Integrated EDID shadow RAM and embedded EDID
• 5V tolerance DDC/HPD I/Os
• Both AC-coupling and DC-coupling Supported

lMiscellaneous

• 1.8V and 3.3V Power Supply
• Support 100KHz and 400KHz I2C Slave
• Support MIPI DCS Config

• Support up to 8-CH SPDIF/I2S Audio Input
• Embedded EEPROM for firmware HDCP keys optionally
• Temperature Range: -40℃ ~ +85℃
• 64-pin QFN 7.5*7.5 package

Description

The LT9611 MIPI® DSI/CSI to HDMI1.4 bridge features a dual-port MIPI® D-PHY receiver front-end configuration with 4 data lanes per port operating at 2Gbps per data lane and a maximum input bandwidth of 16Gbps.
The bridge provides a HDMI data output with optional S/PDIF or 8-channel I2S serial audio input. Its high fidelity 8-channel I2S can transmit stereo up to a 192kHz sampling rate. The S/PDIF can carry stereo LPCM audio or compressed audio, including Dolby® Digital and DTS®. The LT9611 is fabricated in advanced CMOS process and implemented in a small outline 7.5mm x 7.5mm QFN64 package. This package is RoHS compliant and specified to operate from -40°C to +85°C.